DIY APPLICATION GUIDE

Color Seal Application Process for Homogeneous, Porcelain and Ceramic Tiles

Section Title

Preparation:
- Ensure all areas for grout sealing are dry and clean before application.
- It is recommended to use our Tiles & Grout Cleaner to clean the existing grout using a melamine sponge or brush to remove any grease or cleaning chemicals.
- Wipe down the cleaned area with clean water after cleaning.
Color Seal Application:
- Shake the Color Seal bottle well before use.
- Attach the Yorker tip to the bottle and use a toothpick or nail to poke a hole in the Yorker tip.
- After each use, replace the red Yorker tip cap and store the bottle in a cool place (avoid freezing and direct sunlight). The shelf life of the product is approximately 2 years.
Applying the Color Seal:
- Apply Grout Shield Color Seal thinly over the grout lines.
- Use a small watercolor paint brush to spread the Color Seal evenly on the grout lines.
- Use a damp cloth to clean away any excess Color Seal along the sides of the grout lines. Alternatively, you can clean up the excess Color Seal after it dries (about 5 minutes after application).
- It is recommended to apply Color Seal in small sections at a time to allow enough time for cleaning up any excess sealer.
Curing:
- Once the application process is complete, allow the Color Seal to cure for 18 hours.
- Avoid wet cleaning or walking on the grout lines during this curing period.

Preparation:
- Ensure all areas for grout sealing are dry and clean before application.
- It is recommended to use our Tiles & Grout Cleaner to clean the existing grout using a melamine sponge or brush to remove any grease or cleaning chemicals.
- Wipe down the cleaned area with clean water after cleaning.
Color Seal Application:
- Shake the Color Seal bottle well before use.
- Attach the Yorker tip to the bottle and use a toothpick or nail to poke a hole in the Yorker tip.
- After each use, replace the red Yorker tip cap and store the bottle in a cool place (avoid freezing and direct sunlight). The shelf life of the product is approximately 2 years.
Applying the Color Seal:
- Firmly stick masking tapes on both sides of the grout lines.
- Apply Grout Shield Color Seal thinly over the grout lines.
- Use a small watercolor paint brush to spread the Color Seal evenly on the grout lines.
- Allow the Color Seal to dry for approximately 10 minutes, then carefully remove the masking tapes.
- Use a damp cloth or scotch-brite sponge to clean away any excess Color Seal from the edges of the tiles.
- It is recommended to apply Color Seal in small sections at a time to allow enough time for cleaning up any excess sealer.
Curing:
- Once the application process is complete, allow the Color Seal to cure for 18 hours.
- Avoid wet cleaning or walking on the grout lines during this curing period.